No products
New products
-
Bridge and filament test
Bridge and filament test print at 200 microns layer height. Full fan...
R0.00 -
Uglymonkey Filament Holder Steel Frame
Uglymonkey Filament Holder Steel Frame For the Uglymonkey V2.9 and up
R0.00 -
-
-
-
-
-
Hotends
Hotends There are 43 products.
PTFE Tube OD 3mm, ID 2mm, 35mm long
PTFE replacement Tubing for mk8 heatbreak and E3D heatbreak PTFE TUBE ONLY-No Stainless Steel heatbreak included OD = 3mm ID = 2mm Length = 35mm Maximum Temperature = 260 Deg C
R25.00In StockPTFE Tubing, OD 4mm, ID 2mm, 35mm long
PTFE Tubing OD = 4mm ID = 2mm Length = 35mm Maximum Temperature = 260 Deg Used in 3D Printers that use 1.75mm filament. This is a heatbreak insert replacement
R25.00In StockPTFE Tubing, OD 4mm, ID 3mm, 35mm long
PTFE Tubing OD = 4mm ID = 3mm Length = 35mm Maximum Temperature = 260 Deg Used in 3D Printers that use 3mm filament. This is a heatbreak insert replacement
R25.00In StockUglymonkey BuildTak adhesive surface
Uglymonkey BuildTak adhesive surface with 3M Tape 250 X 250 X 0.5mm
R225.00In StockFotek Solid State Relay SSR AC 40A
Fotek 40Amp SSR 3 - 32Volt control side that relays 220 Volts
R360.00In StockE3D V6 Full Metal hotend
E3D V6 Full Metal hotend 1.75mm Filament 0.4mm Nozzle 40Watt Heater 12 Volts 100K Thermistor 30mm 12Volt Fan +- 1 meter cables This hotend is recommended for ABS printing. PLA tends to get stuck in this hotend as it does not have a PTFE liner at all. This is a FULL Metal hotend, for ABS, PLA PLUS, Nylon, etc materials. High heat materials
R495.00In StockPneumatic fitting Tube 4mm 6mm thread
Pneumatic fitting Tube 4mm 6mm thread 6mm thread 4mm tubing
R85.00In StockE3D V6 nozzle fan pack 1.75mm
E3D V6 nozzle fan pack 1.75mm Contains 6 nozzles Spanner and a steel case to keep everything safe.
R450.00In StockE3D V6 Metal hotend PTFE
E3D V6 Metal hotend PTFE 1.75mm Filament 0.4mm Nozzle 40Watt Heater 12 Volts 100K Thermistor 30mm 12Volt Fan +- 1 meter cables
R495.00In Stock
